Gilardoni SP, G5, CX 1000cc round nikisil cylinder piston set

  • Part Number: MG301
  • Manufactured by: Gilardoni
MG Cycle 383.90
$383.90

Currently sold out CURRENTLY SOLD OUT
Order now, and this item will ship to you when new stock arrives

Quantity:
+
-

Gilardoni 1000 SP, V1000 G5, V10000 I-Convert, CX100, 88mm round fin nikisil cylinder and piston set. Original dimension piston and cylinder set yielding standard compression and 949cc. Direct exchange with original equipment. Correct top end kit is part number 1802KIT.

These Gilardoni piston and cylinder sets are without a doubt the best solution to worn, blistered or peeled chrome bores as well as worn or damaged iron cylinder bores. To be cost effective, lesser repair methods (such as boring the old cylinders and installing iron sleeves, or re-plating the old cylinder bores) often re-use the old pistons which typically have suffered wear. Installing sleeves or re-plating used cylinders, and then buying new pistons (if available), piston rings, wrist pins, circlips, etc. can easily meet or exceed the cost of these Gilardoni sets. Sadly, we've sold many of these sets to people that have already spent money on the lesser fixes, only to have to do the job again with the right stuff. Gilardoni is the original equipment manufacturer for several new vehicle manufacturers, and their products have a very good record for performance and longevity.
Each Gilardoni "set" includes 1 new Gilnisil (Nikasil, Nigusil) plated cylinder, 1 new piston, 1 set of rings, 1 wrist pin, and 2 wrist pin circlips. One set is shown in each photo. Two "sets" are required to complete an engine.

18060151

Gilardoni 1000 SP, V1000 G5, V10000 I-Convert, CX100, 88mm round fin nikisil cylinder and piston set. Original dimension piston and cylinder set yielding standard compression and 949cc. Direct exchange with original equipment. Correct top end kit is part number 1802KIT.These Gilardoni piston and cylinder sets are without a doubt the best solution to worn, blistered or peeled chrome bores as well as worn or damaged iron cylinder bores. To be cost effective, lesser repair methods (such as boring the old cylinders and installing iron sleeves, or re-plating the old cylinder bores) often re-use the old pistons which typically have suffered wear. Installing sleeves or re-plating used cylinders, and then buying new pistons (if available), piston rings, wrist pins, circlips, etc. can easily meet or exceed the cost of these Gilardoni sets. Sadly, we've sold many of these sets to people that have already spent money on the lesser fixes, only to have to do the job again with the right stuff. Gilardoni is the original equipment manufacturer for several new vehicle manufacturers, and their products have a very good record for performance and longevity.Each Gilardoni "set" includes 1 new Gilnisil (Nikasil, Nigusil) plated cylinder, 1 new piston, 1 set of rings, 1 wrist pin, and 2 wrist pin circlips. One set is shown in each photo. Two "sets" are required to complete an engine. 18060151