Improved clutch hub holding tool fits both 2mm and 4mm hubs

  • Part Number: 30912810
  • Manufactured by: Moto Guzzi
MG Cycle 45.45
$45.45

In stock IN STOCK

Quantity:
+
-

New and improved clutch hub holding tool for all big twins with 5 speed transmissions, fits both early 2mm and later 4mm deep clutch hubs. Lazer cut thick stainless steel is strong and will not rust. This tool holds the clutch hub (transmission input gear) and prevents it from turning, which allows torquing of the transmission input and output shaft nuts. Replacement for 14912800.

New and improved clutch hub holding tool for all big twins with 5 speed transmissions, fits both early 2mm and later 4mm deep clutch hubs. Lazer cut thick stainless steel is strong and will not rust. This tool holds the clutch hub (transmission input gear) and prevents it from turning, which allows torquing of the transmission input and output shaft nuts. Replacement for 14912800.

This same part number may also be presented in these alternate formats