Handlebar SP1000 V50 V50 II SPIII T5

  • Part Number: 17600360
  • OVERSIZED OR HEAVY ITEM - DOES NOT QUALIFY FOR FLAT RATE SHIPPING
  • Manufactured by: Moto Guzzi
MG Cycle 42.53
$42.53

In stock IN STOCK
Quantity:
+
-

This handlebar for SPIII and the T5 series, is also the substitute for the SP1000, V35s, V50 and V50 II. Dimensions in inches are approximately 27" wide, 6.5" pullback, 8.5" grip section length, 2.75" rise, and 4" center section width. This is a good choice handlebar for a moderate upright seating position on many models. It's relatively low so somewhat sporty, yet the ends pull back more than average to prevent you from having to reach too far forward. Hence, you get a moderately upright sport touring riding position.

Alternate part numbers 30600310 and 65600300, also fitting Benelli 354

This handlebar for SPIII and the T5 series, is also the substitute for the SP1000, V35s, V50 and V50 II. Dimensions in inches are approximately 27" wide, 6.5" pullback, 8.5" grip section length, 2.75" rise, and 4" center section width. This is a good choice handlebar for a moderate upright seating position on many models. It's relatively low so somewhat sporty, yet the ends pull back more than average to prevent you from having to reach too far forward. Hence, you get a moderately upright sport touring riding position. Alternate part numbers 30600310 and 65600300, also fitting Benelli 354

This same part number may also be presented in these alternate formats

  • 17600360
  • 1760 0360
  • 1760.0360
  • 17 60 03 60
  • 17.60.03.60
  • GU17600360

Customers also purchased